SELECT MODE SWITCH IN MDI
Change I/O channel =4
SELECT MODE SWITCH IN REMOTE.
PUNCH PROG PROGRAM KEY.
PUSH RIGHT SOFT ARROW KEY UNTIL [DNC-CD] SHOW UP ON BOTTOM.
PUSH [DNC-CD] SOFT KEY.
PUSH [OPRT] SOFT KEY.
PUNCH 4 DIGIT PROGRAM NUMBER LIKE 0001.
PUSH [DNC-ST] SOFT KEY .
PUSH CYCLE START TO RUN PROGRAM

Add G5.1 Q1 after tool change, use G5.1 Q0 to cancel it, change P7061 to 2.

GOOG17G90G40G49Z0;
M06T5;
G5.1Q1;
………..;
………..;
.
.
.
G5.1Q0;
G00G49G40Z…..;
M30;

1. 1 5/8 inch w 16 (pitch)
2. Pre drill hole 39.7 mm
3. Example program

Before command spindle you need
S1000 M03; ( can ask tooling company best for working material )
N10 X100. Y 17.65 (CENTER OF THREAD COORDINATE)
N20 Z 233.5 (START POINT FOR CUTTING THREAD)
N30 G1 G42 Y38.28 D50 F50 (GO TO THREAD END)

N40 G2 Z231.913 J-20.63 F100 (ONE CIRCUIT OF THREAD)
N50 G0 G40 X100. Y17.65 (GO OUT TO THREAD CENTER)
N60 Z 300.
.
.
.
FOR REFERENCE
Z 233.5-Z231.913= PITCH---1.5875 mm
Y38.28- Y17.65 =J 20.63

When using a thread mill, for example 1.000 to 2.000 inches for O.D. pattern, use the same start point with a different "J" direction.

MO3 S 1000
M29 S 1000
G84 Z-1.0 F 50
G80 MO5

Parenthesis
Edit mode
OPRT (soft key)
Right arrow 2 times (soft key)
C-EXT
Parenthesis (soft key) Example (TEST)
Insert